|48", 60", 72", & 84" Cutting widths
||Wide selection of cutting widths to meet specific applications.
|30-80 hp tractor
||Fits a large array of tractors to meet the needs of consumers, municipalities, and
|Available on 60", 72", and 84" models.
Belt tensioner system brings the belt to proper tension by turning a jam nut. Makes
maintaining proper belt tension easy, and increases belt life.
|0"-6" Cutting height
||Variable cutting height allows operators to scalp the ground, or leave a 1" to 6" cut.
|1", 1 1/2", & 2"
Blade cutting capacity
|Ducksfoot blade can cut up to 1" small brush.
Heavy-duty Y blade can cut up to 1 1/2" brush.
Hammer blade can cut up to 2" small saplings.
|Sealed heavy-duty tapered roller
|Sealed for protection from dust and debris.
Withstand shock loads and deflection from heavy use.
|Reverse rotor rotation
||Brings the cut material up and over which allows it to be dispersed more evenly. Allows
material to be shredded completely
|High knife tip speed
||Knife tip speed 12,046 fpm provides a clean cut, creates a vacuum effect when using
hammer or ducksfoot blades, and slices through saplings with great force when using
heavy-duty Y blades.
|Full width rear access door
||Allows for easy access to blades and rotor for replacing blades and cleaning out debris.
|Quick-change D-ring blade system
||Replace ducksfoot blades without any tools.
|3- “5V” Section Powerband Belt
||Powerband belt distributes load evenly, which prevents the belts from jumping off the
drive when a shock load occurs.
|Hitch offset: 8" for FM2548-60
10" for FM2572-84
|The two position hitch allows the mower to be offset to the right for a closer cut
alongside buildings, fences, and roadsides.
|Three blade options: ducksfoot,
hammer, heavy-duty Y
|Three blade options to meet specific applications.
||Rotor can be removed by unbolting cover plates and bearings.
|Grease zerks on end caps of
driveline cross journals
|Intermediate and main driveline cross journals are easier to grease.
|Standard removable roller scraper
mounted with only two bolts
|Keeps roller clean for consistent cutting height in wet conditions.
Two bolt mounting makes it easy to remove to allow heavy dry cuttings flow freely over
|Front safety chains
||Protects operator and bystanders from debris.
|Replaceable skid shoes
||Prevents wear on end panels from ground contact.